Ryobi String Trimmer Line Replacement: Top Picks & Easy Install Guide
Keeping your Ryobi string trimmer in peak condition starts with understanding the simple yet critical task of line replacement. The cutting line is the only direct contact your tool has with the weeds, grass, and stubborn brush it is designed to conquer, and a worn spool results in frustratingly weak performance.
Whether you are tackling a small residential yard or maintaining a larger property, knowing how to properly load fresh line ensures efficient cutting and prevents damage to the gearbox. This guide walks you through every step, from selecting the correct diameter to troubleshooting common feeding issues.
Understanding Line Diameter and Type
Not all trimmer line is created equal, and using the wrong specification can lead to poor results or even mechanical stress. Ryobi recommends using line with a diameter of .065 inches for most standard applications, although you should always verify this in your specific model's manual.
- Twisted Line: The most common type, ideal for general grass and weed trimming.
- Braid Line: Offers superior cutting power for thicker brush due to its rigid structure.
- Nickel-Plated Line: Resists tangling and provides smoother feeding through the head.
Matching the Gauge to the Job
The gauge, or thickness, of the line directly impacts its durability and cutting ability. A lighter .055-inch line is excellent for quick touch-ups on grass, while a heavy-duty .080-inch line is necessary for tackling woody weeds and thick undergrowth without snapping.
Step-by-Step Replacement Procedure
Before you begin, ensure the tool is unplugged if it is electric or the spark plug is disconnected if it is gas-powered. Allow the trimmer head to cool completely, as the fishing line can retain heat and cause burns during the replacement process.
Follow these steps to remove the old line and install a fresh spool:
- Remove the protective shroud by pressing the release tabs located on the sides of the trimmer head.
- Take out the old spool and inspect the condition of the plastic bump feed mechanism.
- Cut a length of new line approximately 14 to 16 inches long to ensure adequate feeding.
- Thread the line through the holes in the spool, following the directional arrows molded into the plastic.
- Wind the line tightly onto the spool, leaving a small amount of tension to prevent tangling during operation.
- Reinsert the loaded spool into the trimmer head and secure the cover until it clicks into place.
Priming the Line
After reassembly, hold the trimmer vertically and gently tap the head on a hard surface a few times. This action utilizes gravity to pull the line slightly through the housing, ensuring it is positioned correctly for instant cutting power when you begin trimming.
Troubleshooting Common Feeding Issues
Even with the correct installation, you might encounter issues where the line refuses to feed or continues to spin uncontrollably. These problems usually stem from user error or simple mechanical fixes.
| Issue | Likely Cause | Solution |
|---|---|---|
| Line not feeding | Line is tangled or knotted on the spool | Disassemble the head and carefully unwind the line to straighten it |
| Line too short | Insufficient line protruding from the tip | |
| Line spinning freely | Bump trigger stuck in activated position | Inspect the trigger mechanism and the collet sleeve for debris or damage |
Maintaining Your Spool for Longevity
Proper maintenance extends the life of your spool and ensures consistent performance season after season. After each use, check the line for excessive wear and remove any tangled sections before storage.
If the line becomes brittle or develops cracks due to UV exposure or age, replace it immediately. Storing the trimmer with line attached for long periods can cause the plastic to deform, so consider removing the spool if the tool will be idle for weeks.
Safety Best Practices
Personal safety is paramount when handling string trimmer line, as the line rotates at high velocity and can cause serious injury. Always wear safety glasses to protect your eyes from flying debris, and avoid wearing loose clothing or jewelry that could get caught in the mechanism.
When trimming, maintain a firm grip and ensure the tool is under control before initiating movement. Respect the power of the tool, and you will find that a well-maintained Ryobi trimmer makes even the most daunting overgrowth manageable.