Kenmore Dishwasher Normal Wash Light Flashing: 5 Common Fixes & Troubleshooting Guide
Seeing the normal wash light flashing on your Kenmore dishwasher can be a frustrating experience, especially when you have a sink full of dirty dishes waiting. This specific symptom usually indicates the appliance has detected a fault during its cycle and has paused operation as a safety measure. Understanding the underlying reasons for this alert is the first step toward restoring your kitchen routine without costly service calls.
Decoding the Flashing Indicator Light
The behavior of the status lights on modern dishwashers is designed to communicate specific issues. When the normal wash or selected cycle light begins to flash, it is often accompanied by an error code displayed on the control panel or a series of rapid beeps. This alert system differs from a solid illuminated light, which might suggest the machine is simply running; the flash pattern signifies a disruption in the wash process that requires user investigation.
Common Mechanical Culprits
Many instances of the flashing light stem from physical obstructions or drainage issues rather than complex electrical failures. A primary suspect is a clogged filter or drain hose, which prevents water from emptying efficiently. When the unit fails to drain within the expected timeframe, it triggers a fault light to protect the internal components from water damage. Another frequent mechanical cause is a jammed spray arm, which stops the wash water from properly circulating around the load.
- Check the sump area for large debris blocking the drain impeller.
- Inspect the air gap or high loop under the sink for blockages.
- Ensure the spray arm rotates freely without items from the load hindering it.
Electrical and Sensor Diagnostics
If mechanical checks yield no results, the issue likely resides in the electrical system or sensor network. Dishwashers rely on float switches and thermal sensors to monitor water levels and temperature. A malfunctioning float switch, for example, might falsely detect a flood or leak, causing the system to halt operations and flash the warning light. Similarly, a failed heating element sensor can confuse the control board, interrupting the normal wash sequence.
Resetting the Control System
Before diving into disassembly, a simple reset can often resolve temporary electronic glitches that cause the normal wash light to flash. The procedure typically involves turning the circuit breaker off for a few minutes to allow the internal capacitors to discharge. This power cycle resets the motherboard and clears the error code, allowing you to restart the cycle and observe if the problem persists.
When to Seek Professional Repair
While DIY troubleshooting is effective for common issues like a dirty filter or loose hose, some problems require specialized knowledge. If the flashing persists after performing basic maintenance, you may be facing a faulty control board, a defective motor starting capacitor, or a complex sensor failure. Continuing to run the dishwasher in diagnostic mode can lead to further damage, so professional assessment is recommended.
Preventative Maintenance Tips
Preventing the normal wash light from flashing again involves regular upkeep of the machine's internal components. Routinely cleaning the filter mesh and running a maintenance cycle with a dishwasher cleaner helps prevent mineral buildup and debris accumulation. Additionally, being mindful of load placement ensures spray arms remain unobstructed, allowing the machine to complete cycles efficiently without triggering safety alerts.
- Run a hot water cycle in the sink before starting the dishwasher to ensure optimal water temperature.
- Use rinse aid to prevent hard water spotting that can impede draining.
- Check the door seal for debris to ensure a proper closure and pressure seal.