How to Turn Off Your Irrigation System: Easy Step-by-Step Guide
Turning off an irrigation system is often necessary during the winter to prevent pipe damage from freezing, or when the system is not in use for an extended period. Proper shutdown protects your investment and ensures a smooth, trouble-free restart when you need it again in the growing season. The process varies slightly depending on whether you have an automated system with an electronic controller or a manual setup, but the core principle remains the same: remove all residual water from the components.
Identifying Your System Type
Before you begin the shutdown process, it is crucial to identify the type of irrigation system you have. The method for turning it off depends entirely on this factor. A professional underground system typically uses a pressurized network of PVC or polyethylene pipes and requires a specific sequence of steps to drain the water. Conversely, a temporary setup using a garden hose with built-in emitters or a soaker hose can often be turned off much more simply by shutting off the water source at the tap.
Manual Shutdown for Hose-End Systems
For gardeners using a simple hose-end system, the procedure is straightforward and does not usually require blowing out lines. To turn off this type of irrigation, you should first turn off the water supply at the outdoor faucet. Next, remove the timer or any connected filters and allow the system to drain naturally. Finally, roll up the hoses and store them in a dry place to prevent damage and tangling for the next season.
Preparing the Controller
The control panel or timer is the brain of your automated system, and handling it correctly is a vital part of how to turn off irrigation. You should not simply turn the main water valve off; you must also adjust the settings on the controller. Most units feature a "Rain Delay" or "Seasonal Adjustment" setting. Set this to 0% or turn the system dial to the "Off" position to prevent any accidental activation during the shutdown period.
The Main Line Shut-OffLocating the main shut-off valve is the next critical step in the process. This valve is usually found near the water meter, inside a utility box, or where the irrigation line connects to your home's plumbing. Carefully turn this valve clockwise until it stops. It is important to note that this action only stops fresh water from entering the system; it does not drain the pipes that are already filled. If this valve is not clearly marked, you may need to consult a property map or contact your water supplier for identification assistance.
Draining the System: The Blow-Out Method
For most underground sprinkler systems, gravity alone is insufficient to remove all the water. The most effective and recommended method is the air blow-out technique. This involves connecting a high-air-pressure compressor to the system's blow-out port. Professionals typically use an air compressor with a pressure regulator set to around 50 PSI. The compressed air forces the water out of the heads and valves, ensuring the lines are dry and protected from freezing temperatures.
Draining Alternative: Gravity Manual Drainage
If you do not have access to an air compressor, you can manually drain the system by opening the valves. After turning off the main water supply, locate the drain valves or the lowest points in the piping network. Open these valves to allow water to escape. You will also need to manually lift the sprinkler heads to help water flow out of the low spots in the lines. While this method is effective, it requires significant time and can be labor-intensive, often leaving behind small amounts of moisture that are susceptible to freezing in very cold climates.
Winterization and Long-Term Storage
Once the water is removed, the system is technically winterized. However, the process of how to turn off irrigation also includes protecting the components. Above-ground components like the backflow preventer and any above-ground valves should be insulated with covers to protect them from freezing weather. For battery-operated controllers, remove the batteries to prevent corrosion. Store hoses, timers, and filters indoors in a cool, dry location to extend their lifespan and prevent damage from UV exposure or pests.