Easy DIY: How to Install a Pop-Up Drain in Your Yard Fast
Installing a pop up drain in your yard is a practical solution for managing surface water, preventing puddling, and improving the overall health of your lawn. This system directs runoff to a designated drainage point, such as a storm drain or dry well, keeping your landscape functional and visually appealing. While it requires some DIY effort, the project is achievable with the right tools and a clear plan.
Planning Your Drain Location
The success of a pop up drain starts with strategic planning. You must identify the lowest point in your yard where water naturally collects, as this is the ideal location for the drain inlet. It is crucial to check local regulations regarding stormwater runoff and underground utilities before you begin; contacting your local utility locating service is a necessary step to avoid damaging gas, water, or electrical lines.
Understanding Local Codes
Municipal codes often dictate where and how you can discharge collected water. Some areas require the water to be directed to the street storm drain system, while others encourage infiltration systems to prevent overwhelming public sewers. Securing the necessary permit ensures your installation is legal and avoids potential fines or having to undo your work later.
Gathering Tools and Materials
Having the correct materials on hand streamlines the installation process and prevents delays. You will need a sturdy pop up drain inlet and housing, PVC piping, a PVC primer and cement, gravel for the base, and a compactable fill material like decomposed granite. Additionally, a post digger or trenching spade is essential for creating a smooth pathway for the pipe.
| Item | Purpose |
| Pop Up Drain Inlet | Collects surface water and sits flush with the grass. |
| PVC Pipe (Schedule 40) | Transports water from the inlet to the discharge point. |
| Gravel | Provides drainage under the pipe and around the base. |
| Trenching Tools | Used to dig a consistent slope for the pipe. |
Digging the Trench
Once you have your location and materials, you can begin digging. The trench needs to be deep enough to accommodate the PVC pipe with a slight slope that encourages water flow. A general rule of thumb is a drop of about 1/4 inch for every foot of pipe length to ensure the water moves efficiently without stagnating.
Maintaining the Slope
Consistency is key when digging the trench. Use a line level or a string tied between stakes to ensure the pipe follows a steady downward grade. The pipe should run smoothly from the drain inlet to your exit point, whether that is a storm drain, ditch, or dry creek bed. Avoid sharp bends, as they can clog the flow.
Installing the Drain System
With the trench prepared, you can lay the pipe and install the inlet. Place a layer of gravel at the bottom of the trench to facilitate water percolation if you are not using a solid pipe to a discharge point. Assemble the PVC sections using primer and cement, ensuring all joints are secure to prevent leaks.
Securing the Inlet
The pop up drain housing should be set into the trench and connected to the PVC pipe. Backfill around the housing with gravel to provide stability and ensure water flows directly into the inlet. Finally, cover the mechanism with a thin layer of soil, leaving the upper disc slightly proud of the ground so it rises cleanly when water fills the basin.
Testing the Installation
After the system is assembled, a thorough test is necessary. Pour a few gallons of water into the drain inlet and observe the flow. The water should disappear quickly and exit the pipe without pooling. Check the pop up cap to ensure it resets smoothly and sits flush with the lawn after the water has drained.
Long-Term Maintenance
To keep the drain functioning, periodically remove debris from the inlet cover. Leaves, grass clippings, and dirt can block the grate and reduce efficiency. By staying proactive with simple cleaning, you ensure the drain continues to protect your yard from water damage year after year.