How to Change a Bathtub to a Shower: Step-by-Step Guide
Converting a bathtub to a shower is one of the most effective ways to modernize a bathroom, improve accessibility, and increase floor space. This project requires careful planning, precise measurements, and a clear understanding of plumbing and waterproofing principles. While the task is complex, the result is a daily upgrade that enhances both functionality and aesthetics.
Initial Assessment and Planning
Before removing a single tile, evaluate the feasibility of the conversion. Consider the available space, the location of the main water supply lines, and the position of the floor drain. If the current drain is positioned far from the desired shower location, extending the plumbing can significantly increase labor and material costs.
Additionally, think about the type of shower you want—standard stall, neo-angle, or walk-in—since the design dictates the framing layout. Consulting a local building code official or a permit office early on ensures your plans comply with safety standards regarding drainage slope and waterproofing requirements.
Gathering Tools and Materials
A successful conversion relies on having the right tools for cutting, removing, and rebuilding. You will need a reciprocating saw, pry bar, tape measure, level, and a utility knife. For the new shower, purchase a high-quality pan or prefabricated unit, appropriate studs, cement board, and a reliable waterproofing membrane.
- Reciprocating saw with metal-cutting blades
- Plunger and closet auger (for drain clearing)
- Cement backer board and thin-set mortar
- Waterproofing membrane and pan sealant
- Adjustable wrenches and pipe cutters
Removing the Existing Bathtub
Drain all standing water and turn off the water supply to the bathroom. Disconnect the faucet handles and drain lines, and carefully remove any decorative caps or overflow plates. Use a reciprocating saw to cut through the caulk and trim along the edges of the tub.
Break the tub into manageable sections using a sledgehammer or a demolition tool, then extract the debris. Be cautious of sharp edges and dispose of the old tub according to local waste regulations. This stage is messy, so covering the floor with drop cloths and wearing protective gear is essential.
Plumbing and Drain Adjustments
Inspect the existing shut-off valves and supply lines; replace any corroded fixtures to prevent future leaks. The shower head requires a higher volume of water pressure, so verify that the home’s plumbing can support this demand without a noticeable drop in pressure elsewhere in the house.
| Plumbing Task | Description |
|---|---|
| Shut-off Valve Replacement | Upgrade to new quarter-turn valves for easier isolation. |
| Drain Relocation | Only if necessary; involves cutting and re-piping PVC. |
| Slope Verification | Ensure the new pan slopes toward the drain to prevent pooling. |
Framing and Waterproofing
Install a sturdy wood or steel framework to support the new walls. If using wood, ensure the studs are spaced correctly to accommodate cement board or plywood. Attach the backer board with corrosion-resistant screws, keeping seams tight to avoid structural weakness.
Once the substrate is secured, apply a liquid waterproofing membrane or a peel-and-stick membrane over all joints and corners. Extend the protection up the walls at least 36 inches above the shower head level and 6 inches onto the floor. Properly sealing this area prevents water damage to the subfloor and adjacent walls.
Installing the Shower System
With the waterproofing complete, set the prefabricated pan or build the mortar bed to the exact height required for the drain. Position the mixing valve and rough-in the pipes for the shower arm, ensuring the height aligns with the finished wall measurement. Secure the valve tightly to prevent future movement or leaks.
Attach the wall panels, tile the surfaces, and install the fixtures, including the handle, diverter, and showerhead. Test the system thoroughly by running water at high pressure for an extended period. Check the surrounding areas for any signs of moisture intrusion before closing the walls completely.